Hyundai Creta: General Information / Troubleshooting

Hyundai Creta GS 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / General Information / Troubleshooting

Troubleshooting

Problem Symptoms Table

Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.

Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.

After correcting the malfunction, check the complete system to ensure that performance is satisfactory.

Standard:

Symptom	Suspected Area
No blower operation	1. Blower fuse
	2. Blower relay
	3. Blower motor
	4. Power mosfet
	5. Blower speed control switch
	6. Wire harness
No air temperature control	1. Engine coolant capacity
No air temperature control	2. Heater control assembly
No compressor operation	1. Refrigerant capacity
	2. A/C fuse
	3. Compressor
	4. A/C pressure transducer
	5. A/C switch
	6. Evaporator temperature sensor
	7. Wire harness
Vented air not cold	1. Refrigerant capacity
	2. Refrigerant pressure
	3. Drive belt
	4. Compressor
	5. A/C pressure transducer
	6. Evaporator temperature sensor
	7. A/C switch
	8. Heater control assembly
	9. Wire harness
Insufficient cooling	1. Refrigerant capacity
	2. Drive belt
	3. Compressor
	4. Condenser
	5. Expansion valve
	6. Evaporator
	7. Refrigerant lines
	8. A/C pressure transducer
	9. Heater control assembly
No engine idle-up when A/C switch is ON	1. Engine ECM
No engine idle-up when A/C switch is ON	2. Wire harness
No air inlet control	1. Heater control assembly
No mode control	1. Heater control assembly
No mode control	2. Mode actuator
No cooling fan operation	1. Cooling fan fuse
	2. Fan motor
	3. Engine ECM
	4. Wire harness

Specifications

Specification Air Conditioner Item Specification Compressor Type 6VSX14 Oil type & Capacity ...

Special service tools

Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3. Remove the body control module (A) after disconne ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of th ...