Hyundai Creta: Tires and wheels / Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.
If you notice your vehicle vibrating when driving on a smooth road, your wheels may need to be rebalanced.
NOTICE
Improper wheel weights can damage your vehicle's aluminum wheels. Use only approved wheel weights.
Tire rotation
To equalize tread wear, it is recommended
that the tires be rotated
every 12,000 km (7,500 miles) or
sooner if irregular wear develops.
During rotation, check the tires for
correct balance.
...
Tire replacement
If the tire is worn evenly, a tread wear
indicator will appear as a solid band
across the tread. This shows there is
less than 1.6 mm (1/16 inch) of tread
left on the tire. Replace the tire ...
Other information:
Hyundai Creta GS 2014-2025 Service Manual: Components and components location
Components
1. Front pillar trim
2. Cowl side trim
3. Front door scuff trim
4. Center pillar lower trim
5. Center pillar upper trim
6. Rear door scuff trim
7. Rear pillar trim
8. Front door step trim
9. Rear door step trim
...
Hyundai Creta GS 2014-2025 Service Manual: Power Door Mirror Actuator
Components and components location
Components
Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (B) after removing the front door quadrant
cover (A).
...
