Hyundai Creta: Wipers and washers / Windshield washers

In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wiper operation will continue until you release the lever.

If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.

The reservoir filler neck is located in the front of the engine compartment on the passenger side.

WARNING

When the outside temperature is below freezing, ALWAYS warm the windshield using the defroster to prevent the washer fluid from freezing on the windshield and obscuring your vision which could result in an accident and serious injury or death.

NOTICE

Windshield wipers
Operates as follows when the ignition switch is in the ON position. MIST : For a single wiping cycle, move the lever to or MIST position and release. The wipers will operate continuously if ...

Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. HI – High ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Schematic diagrams
Schematic diagram Terminal Function ABS Connector Input/ Out put Wire No. Designation Current12V(AMPS) max.permissible wire resistance (OHMS) 13 Ground for recirculation pump ...

Hyundai Creta GS 2014-2019 Owners Manual: Closing the tailgate
To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING Make sure your hands, feet and other parts of your body are safely out of the way before closing the tailgate. NOTICE Make sure nothing is near the tailgate latc ...

© 2017-2026 www.hcrmangs.com