Hyundai Creta: Wipers and washers / Windshield wipers
Operates as follows when the ignition switch is in the ON position.
MIST : For a single wiping cycle, move the lever to or MIST position and release. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at the same wiping intervals. To vary the speed setting, move the speed control lever.
Information
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
If you do not remove the snow and/or ice before using the wiper and washer, it may damage the Wiper and washer system.
Wipers and washers
A : Wiper speed control (front)
/ MIST – Single wipe
O / OFF – Off
--- / INT – Intermittent wipe
AUTO* – Auto control wipe
1 / LO– Low wiper speed
2 / HI – High wiper speed ...
Windshield washers
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. Use this function
when the windshield is dirty. The
spray an ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Front Door Belt Outside Weatherstrip: Repair procedures
Replacement
1.
Pull down front door window glass by pressing the power window glass
switch.
2.
Remove the front door belt outside weatherstrip (A).
3.
To install, reverse the removal procedure.
...
Hyundai Creta GS 2014-2019 Service Manual: Engine Control Module (ECM)
Schematic diagrams
ECM Terminal And Input/Output
signal [M/T]
ECM Terminal Function
(M/T)
Connector [E100-MA]
Pin No.
Description
Connected to
1
-
　
2
...
