Hyundai Creta: Clutch System / Clutch Pedal
Components and components location
| Components |
| 1. Clutch pedal assembly 2. Clutch pedal arm 3. Ignition lock & clutch switch 4. Washer |
5. Snap pin 6. Master cylinder 7. Reservoir hose |
Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the crash pad lower pannel.
(Refer to Body - "Crash Pad")
|
| 3. |
Disconnect the ignition lock & clutch switch connector (A).
|
| 4. |
Disconnect the push rod from the clutch pedal by removing the snap pin
(A) and washer (B).
|
| 5. |
Remove the clutch pedal mounting nuts (C-4ea).
|
| 6. |
Remove the clutch pedal assembly from the vehicle.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Clutch Switch
Specifications
Specifications
Item
Specifications
Working voltage
DC 12V
Operating force
Initial posi ...
Clutch Tube
Components and components location
Components
[M6CF1]
1. Clutch
pedal assembly
2. Clutch pedal arm
3. Ignition lock & clutch switch
4. Washe ...
Other information:
Hyundai Creta GS 2014-2019 Owners Manual: Rear combination light bulb
replacement
(1) Stop/Tail light
(2) Tail light
(3) Rear turn signal light
(4) Back-up light
Outside light
1. Open the tailgate
2. Loosen the light assembly retaining
screws with a cross-tip screwdriver.
3. Remove the rear combination light
assembly from the body of the
vehicle.
4. Remove ...
Hyundai Creta GS 2014-2019 Owners Manual: Checking the engine oil level
1.Be sure the vehicle is on level
ground.
2.Start the engine and allow it to
reach normal operating temperature.
3.Turn the engine off and wait for a
few minutes (about 5 minutes) for
the oil to return to the oil pan.
4.Pull the dipstick out, wipe it clean,
and reinsert it fully.
WAR ...
