Hyundai Creta: Front Seat / Front Seat Assembly

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly

Components and components location

Component Location

1. Front seat assembly

Repair procedures

Replacement

Open the front seat mounting bolt cap (A), then loosen the mounting bolts (B).

Tightening torque :

44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.5 ~ 43.4 Ib-ft)

[Front]

[Rear]

2.	Disconnect the connector (A). [Driver's] [Passenger's]

To install, reverse the removal procedure.

SEAT MOUNTING BOLT INSTALLATION PROCEDURE

•	Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.

•	Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.

•	Set the seat into the most rearward position. Check the front mounting bolt completely.

•	Check that the seat operates to and fro smoothy and the locking portion locks properly.

Components and components location

Components 1. Recliner lever 2. Front seat outer shield cover 3. Front seat cushion frame assembly 4. Front seat cushion cover 5. Front seat shield inner cover ...

Front Seat Shield Outer Cover

Components and components location Component Location 1. Front seat shield outer cover Repair procedures Replacement ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Front Stabilizer Bar: Repair procedures
Removal 1. Remove the front wheel and tire (A). Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Separate the stabilizer link (B) from the front st ...

Hyundai Creta GS 2014-2019 Service Manual: Input Speed Sensor
Description and operation Description • Input speed sensor uses an electric current type hall sensor in which the current is changed by the magnetic variation. • Input speed sensor (A) and output speed sensor are integrated an ...