Hyundai Creta: What to do in an emergency / If the engine will not start
If the engine doesn't turn over or turns over slowly
- Be sure the shift lever is in N (Neutral) or P (Park) if it is an automatic transaxle vehicle. The engine starts only when the shift lever is in N (Neutral) or P (Park).
- Check the battery connections to be sure they are clean and tight.
- Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained.
Do not push or pull the vehicle to start it. This could cause damage to your vehicle.
See instructions for "Jump Starting" provided in this chapter.
WARNING
Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.
If the engine turns over normally but doesn't start
- Check the fuel level and add fuel if necessary.
If the engine still does not start, we recommend that you call an authorized HYUNDAI dealer for assistance.
In case of an emergency while driving
If the engine stalls while driving
Reduce your speed gradually,
keeping a straight line. Move cautiously
off the road to a safe place.
Turn on your hazard warning flasher.
Try to start t ...
Jump starting
Jump starting can be dangerous if
done incorrectly. Follow the jump
starting procedure in this section to
avoid serious injury or damage to
your vehicle. If in doubt about how to
properly ju ...
Other information:
Hyundai Creta GS 2014-2019 Owners Manual: Warning and indicator lights
Air bag Warning Light
Once you set the ignition switch or
Engine Start/Stop button to the ON
position.
- It illuminates for approximately 6
seconds and then goes off.
When there is a malfunction with
the SRS.
In this case, we recommend that
you have the vehicle inspected ...
Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Adjustment
Transaxle Control Module
(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
•
Transaxle assembly ...
