Hyundai Creta: Immobilizer System / Immobilizer Control Unit: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut and a bolt.

Installation
1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the crash pad lower panel.
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehi ...

Antenna Coil: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column shroud panel. (Refer to Body - "Crash P ...

Other information:

Hyundai Creta GS 2014-2019 Owners Manual: Key ignition switch
WARNING NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control ...

Hyundai Creta GS 2014-2019 Service Manual: Auto Defogging Sensor
Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moi ...

В© 2017-2026 www.hcrmangs.com