Head Restraint Components

The head restraints consist of:
Adjusting the Head Restraint
WARNING: Fully adjust the head restraint before you sit in or operate your vehicle. This will help minimize the risk of neck injury in the event of a crash. Do not adjust the head restraint when your vehicle is moving.
WARNING: The head restraint is a safety device. Whenever possible it should be installed and properly adjusted when the seat is occupied. Failure to adjust the head restraint properly could reduce its effectiveness during certain impacts.
Note: Adjust the seat backrest to an upright driving position before adjusting the head restraint. Adjust the head restraint so that the top of it is level with the top of your head and as far forward as possible. Make sure that you remain comfortable. If you are extremely tall, adjust the head restraint to its highest position.
Pull the head restraint up to raise it.
To lower the head restraint:
Removing the Head Restraint
Note: You cannot remove front seat head restraints that have entertainment system video screens.
Installing the Head Restraint
Align the steel stems into the guide sleeves and push the head restraint down until it locks.
Adjusting the Power Head Restraint (If Equipped)

Moving the Seat Backward and Forward

Adjusting the Seat Cushion (If Equipped)

Adjusting the Length of the Seat Cushion (If Equipped)

Adjusting the Seat Backrest
WARNING: Do not place cargo or any objects behind the seatback before returning it to the original position.

Adjusting the Upper Seat Backrest and Head Restraint (If Equipped)

Adjusting the Seat Height

Adjusting the Lumbar Support

Sitting in the Correct Position
Massage SeatsHyundai Creta GS 2014-2025 Service Manual: Troubleshooting
Basic Troubleshooting
Basic Troubleshooting
Guide
Customer Problem Analysis
Sheet
Basic Inspection Procedure
Measuring Condition Of Electronic Parts' Resistance
The measured resistance at high temperature after vehicle ru ...
Hyundai Creta GS 2014-2025 Service Manual: Main Crash Pad Assembly
Components and components location
Component Location
1. Main crash pad assembly
Repair procedures
Replacement
•
Put on gloves to pro ...