Hyundai Creta: Horn / Repair procedures
| Removal |
| 1. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 2. |
After loosening each mounting bolt of the high-pitch horn (A) and low-pitch
horn (B), detach the connector (C) and remove the horn.
|
| Installation |
| 1. |
Install the horns after connecting the horn connectors.
|
| 2. |
Install the front bumper cover.
|
| Inspection |
Test the horn by connecting battery voltage to the 1 terminal and ground the
2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
Horn relay is installed on the PCB fuse & relay block in the engine room block.
This PCB relay is needed to replace with the PCB fuse & relay block assembly
only.
Components and components location
Component Location
1. Horn switch
2. Horn relay (Engine room - PCB Fuse & Relay Block)
3. Horn (Low pitch)
4. Horn (High pitch)
5. Clock spring
...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Components
1. Rear door trim
2. Rear door belt inside weatherstrip
3. Rear door trim seal
4. Rear door panel
5. Rear door belt outside weatherstrip
6. Rear door body side weatherstrip
7. Rear door side weatherstrip
8. Rear door hinge
...
Hyundai Creta GS 2014-2019 Service Manual: Special service tools
Special Service Tools
Tool Name / Number
Illustration
Description
Fuel Pressure Gauge
09353-24100
Used for measuring the pressure
in fuel line
Fuel Pressure Gauge Adapter
0935 ...
В© 2017-2026 www.hcrmangs.com
