Hyundai Creta: Keyless Entry And Burglar Alarm / Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

Disconnect the connectors from the actuator.

NO	Pin information
NO	LH	RH
1	Motor 1	AJAR Switch
2	Motor 2	COM
3	-	Lock / UnLock switch
4	Key Unlock switch	Key Lock switch
5	Key Lock switch	Key Unlock switch
6	Lock / UnLock switch	-
7	COM	Motor 2
8	AJAR Switch	Motor 1

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Latch Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear latch. (Refer to Body - "Rear Door Latch")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Lock Module Inspection

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the 4P connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the switch connector.

3.	Check for continuity between the terminals in each switch position according to the table.

Hood Switch

1.	Disconnect the connector (A) and bolts from the hood switch.

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn

1.	Remove the burglar horn (A) after removing a bolt and disconnect the 2P connector from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should sound. If the burglar horn fails to sound replace it.

Description and operation

Description Burglar Alarm State [B/A State] B/A State Description DISARM 1) This is the state whe ...

Transmitter: Repair procedures

Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the batte ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Tail Gate Assembly
Components and components location Component Location 1. Tail gate assembly Repair procedures Replacement • Wear gloves to protect han ...

Hyundai Creta GS 2014-2019 Owners Manual: Cigarette lighter
To use the cigarette lighter, the ignition switch must be in the ACC or ON position. Push the cigarette lighter all the way into its socket. When the element is heated, the lighter will pop out to the “ready” position. We recommend that you use parts for replacement from an autho ...