Troubleshooting |
Problem Symptoms Table |
Symptom |
Suspected Area |
No blower operation |
1. Blower fuse |
2. Blower relay |
|
3. Blower motor |
|
4. Power mosfet |
|
5. Blower speed control switch |
|
6. Wire harness |
|
No air temperature control |
1. Engine coolant capacity |
2. Heater control assembly |
|
No compressor operation |
1. Refrigerant capacity |
2. A/C fuse |
|
3. Compressor |
|
4. A/C pressure transducer |
|
5. A/C switch |
|
6. Evaporator temperature sensor |
|
7. Wire harness |
|
Vented air not cold |
1. Refrigerant capacity |
2. Refrigerant pressure |
|
3. Drive belt |
|
4. Compressor |
|
5. A/C pressure transducer |
|
6. Evaporator temperature sensor |
|
7. A/C switch |
|
8. Heater control assembly |
|
9. Wire harness |
|
Insufficient cooling |
1. Refrigerant capacity |
2. Drive belt |
|
3. Compressor |
|
4. Condenser |
|
5. Expansion valve |
|
6. Evaporator |
|
7. Refrigerant lines |
|
8. A/C pressure transducer |
|
9. Heater control assembly |
|
No engine idle-up when A/C switch is ON |
1. Engine ECM |
2. Wire harness |
|
No air inlet control |
1. Heater control assembly |
No mode control |
1. Heater control assembly |
2. Mode actuator |
|
No cooling fan operation |
1. Cooling fan fuse |
2. Fan motor |
|
3. Engine ECM |
|
4. Wire harness |
Hyundai Creta GS 2014-2024 Service Manual: Description and operation
Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions
are pre-pro grammed in the memory of the ECM (Engine Control Module).
The engine operating conditio ...
Hyundai Creta GS 2014-2024 Service Manual: Troubleshooting
Troubleshooting
Symptom
Suspected Area
Remedy
Abnormal noise
Oil level (Low)
To adding oil after inspect the parts (Oil seal, Drain plug, filler plug).
Oil (Wrong)
Replace t ...