Hyundai Creta: Tires/Wheels / Wheel: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Suspension System / Tires/Wheels / Wheel: Repair procedures

Inspection

Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque (Front) :

88.25 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Tightening torque (Rear) :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

•	When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.012)	Below 1.0(0.039)
Axial mm(in.)	Below 0.3(0.012)	Below 0.6(0.024)

3.	If measured value exceeds the standard value, replace the wheel.

Tire: Repair procedures

• Using tires and wheel other than the recommended sizes could cause unusual handling chara ...

Alignment: Repair procedures

Front Wheel Alignment • When using a commercially available computerized wheel alignm ...

Other information:

Hyundai Creta GS 2014-2019 Owners Manual: Opening the hood
1. Make sure the shift lever is in P (Park, for automatic transaxle) or first gear or R (Reverse, for manual transaxle) and set the parking brake. 2. Pull the release lever to unlatch the hood. The hood should pop open slightly. 3. Go to the front of the vehicle, raise the hood sli ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels are placed in the straight ahead position. 3. ...