Hyundai Creta: Front Bumper / Front Bumper Cover

Components and components location

Component Location

1. Front bumper cover


Repair procedures

Replacement
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the radiator upper cover mounting bolts.

2.
Loosen the front bumper lower mounting bolts.

3.
After loosening the front bumper side's mounting screw, then disconnect the side's.

4.
Disconnect the fog lamp connector (A).

5.
Remove the front bumper cover (A).

6.
To install, reverse the removal procedure.
  
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
Components and components location
Components 1. Front bumper cover 2. Front bumper side bracket [LH] 3. Front bumper side bracket [RH] ...

Radiator Grill
Components and components location Component Location 1. Radiator grill Repair procedures Replacement   ...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Mode Control Actuator
Components and components location Components Location 1. Mode control actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the ...

Hyundai Creta GS 2014-2025 Owners Manual: Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. To close the sunglass holder, push back into position. Make sure the sunglass holder is closed while driving. WARNING Do not kee ...

© 2017-2025 www.hcrmangs.com