Hyundai Creta: Manual Transaxle System / Manual Transaxle Fluid

Hyundai Creta GS 2014-2019 Service Manual / Manual Transaxle System / Manual Transaxle System / Manual Transaxle Fluid

General information

General Information

Check & Change intervals

Check & Replenishment

Change

Capacity

Oil specification

Normal Use

Severe Use

60000 km / 4 years
(40000 miles / 4years)

No service required

120000 km
(80000 miles)

1.6 ~ 1.7
(0.42 ~ 0.44 U.S gal., 1.69 ~ 1.79 U.S.qt., 1.41 ~ 1.49 lmp qt.)

API Service GL-4, SAE 70W
• Recommended oil

–	SHELL : SPIRAX S6 GHME 70W

–	SK : HK MTF 70W

–	GS CALTEX : GS MTF HD 70W

Severe usage is defined as

•	Driving in dusty, rough roads

•	Driving in areas using salt or other corrosive materials or in very cold weather

•	Driving in sandy areas

•	Driving in mountainous areas

•	Towing a trailer

•	Driving for patrol car, taxi, commercial car or vehicle towing

•	Driving over 170 Km

Repair procedures

Inspection

1.	Stop the engine and uplift the vehicle with lift.

2.	Loosen the oil filler plug (A).

Check the oil level.

Oil level must be up to fill the hole, if not, add oil until it runs over.

Install the filler plug.

Tightening torque:

58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

Replacement

1.	Uplift the vehicle with lift.

2.	Drain the manual transaxle oil after loosening the drain plug (A).

Install the drain plug with new gasket.

Tightening torque:

58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)

4.	Loosen the oil filler plug (A).

Add new oil through the filler plug hole and, fill it just below the plug opening.

Standard oil: API Service GL-4, SAE 70W

Recommnend oil (- SHELL : SPIRAX S6 GHME 70W, SK : HK MTF 70W, GS CALTEX : GS MTF HD 70W)

Oil capacity: 1.6 ~ 1.7 (0.42 ~ 0.44 U.S gal., 1.69 ~ 1.79 U.S.qt., 1.41 ~ 1.49 lmp qt.)

Install the oil filler plug.

Tightening torque:

58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

Manual Transaxle

Components and components location Components 1. Control shaft complete 2. Back-up lamp switch 3. Control cable bracket 4. Plug Repair procedures ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Purge Control Solenoid Valve (PCSV)
Description and operation Description Purge Control Solenoid Valve (PCSV) is a solenoid valve and is installed on the surge tank and controls the passage between the canister and the intake manifold. The evaporative gases gathered in the canister are delivered to the intak ...

Hyundai Creta GS 2014-2019 Service Manual: BJ Boot
Components and components location Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retainer ring ...