Hyundai Creta: General Information / Troubleshooting
| Troubleshooting |
| Problem Symptoms Table |
Use the table below to help you find the cause of the problem. The numbers indicate
the priority of the likely cause of the problem. Check each part in order.
If necessary, replace these parts.
|
Symptom |
Suspected Area |
Reference |
|
Lower pedal or spongy pedal |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Piston seals (Worn or damaged) 4. Rear brake shoe clearance(Out of adjustment) 5. Master cylinder (Inoperative) |
repair air·bleed replace adjust replace |
|
Brake drag |
1. Brake pedal free play (Minimum) 2. Parking brake lever travel (Out of adjustment) 3. Parking brake wire (Sticking) 4. Rear brake shoe clearance(Out of adjustment) 5. Pad or lining (Cracked or distorted) 6. Piston (Stuck) 7. Piston (Frozen) 8. Anchor or Return spring (Inoperative) 9. Booster system (Vacuum leaks) 10. Master cylinder (Inoperative) |
adjust adjust repair adjust replace replace replace replace repair replace |
|
Brake pull |
1. Piston (Sticking) 2. Pad or lining (Oily) 3. Piston (Frozen) 4. Disc (Scored) 5. Pad or lining (Cracked or distorted) |
replace replace replace replace replace |
|
Hard pedal and inefficient brake |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Pad or lining (Worn) 4. Pad or lining (Cracked or distorted) 5. Rear brake shoe clearance(Out of adjustment) 6. Pad or lining (Oily) 7. Pad or lining (Glazed) 8. Disc (Scored) 9. Booster system (Vacuum leaks) |
repair air·bleed replace replace adjust adjust replace replace repair |
|
Noise from brake |
1. Pad or lining (Cracked or distorted) 2. Installation bolt (Loosen) 3. Disc (Scored) 4. Sliding pin (Worn) 5. Pad or lining (Dirty) 6. Pad or lining (Glazed) 7. Anchor or Return spring (Faulty) 8. Brake pad shim (Damage) 9. Shoe hold-down spring (Damage) |
replace adjust replace replace clean replace replace replace replace |
|
Brake fades |
1. master cylinder |
replace |
|
Brake vibration, pulsation |
1. brake booster 2. pedal free play 3. master cylinder 4. caliper 5. master cylinder cap seal 6. damaged brake lines |
replace adjust replace replace replace replace |
|
Brake Chatter |
Brake chatter is usually caused by loose or worn components, or glazed or
burnt linings. Rotors with hard spots can also contribute to brake chatter.
Additional causes of chatter are out-of-tolerance rotors, brake lining not
securely attached to the shoes, loose wheel bearings and contaminated brake
lining. |
|
Special service tools
Special Service Tools
Tool(Number and Name)
Illustration
Use
09581- 2T100
Piston expander
Sprea ...
Brake System
...
Other information:
Hyundai Creta GS 2014-2026 Service Manual: Engine Mounting
Components and components location
Components
1. Transaxle mounting bracket
2. Roll rod bracket
3. Engine mounting bracket
4. Engine mounting support bracket
Repair procedures
Removal and Installation
Roll rod Bracket
1. ...
Lincoln Nautilus 2018-2026 Owners Manual: Using the Valet Mode. Using the Backup Start Passcode
Using the Valet Mode
Press Settings on the touchscreen.
Press Valet Mode.Note: Have your Backup Start Passcode
completely setup before using Valet Mode.
Note: Once the system detects a valid Phone
as a Key, the temporary passcode displays
in both the touchscreen and mobile app. If
the sy ...
© 2017-2026 www.hcrmangs.com
