Hyundai Creta: Blower / Blower Motor: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Motor: Repair procedures

Inspection

1.	Connect the battery voltage and check the blower motor rotation.

2.	If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

3.	Replace the blower motor if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

3.	Install in the reverse order of removal.

Blower Unit

Components and components location Component Location 1. Blower unit assembly Components 1. Inlet Seal 2. Intake duct case ...

Blower Resistor (Manual): Repair procedures

Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS)
Description and operation Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, fuel is not supplied.That is, vehicle can't run without CKPS sig ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs. • If a DTC ...