Hyundai Creta: Blower / Blower Resistor (Manual): Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Resistor (Manual): Repair procedures

Inspection

1.	Measure the resistance between the terminals.

2.	The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Housing")

3.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Blower Motor: Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substi ...

Power Mosfet (DATC)

Description and operation Description It is installed to the DATC and adjusts the fan rpm by precisely controlling the voltage applied to the blower motor. Repair procedures ...

Other information:

Hyundai Creta GS 2014-2019 Owners Manual: Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you depress the brake pedal. Please remember some driving conditions or climates may cause a ...

Hyundai Creta GS 2014-2019 Service Manual: Engine Control Module (ECM)
Schematic diagrams ECM Terminal And Input/Output signal [M/T] ECM Terminal Function (M/T) Connector [E100-MA] Pin No. Description Connected to 1 - 　 2 ...