Hyundai Creta: Manual Transaxle Control System / Control Shaft Assembly
Hyundai Creta GS 2014-2019 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Assembly
Description and operation
| Description |
Control shaft assembly is mounted on the top of the manual transmission, and
select & shift cable are equipped.
Control shaft assembly is operated by shifting the shift lever.
Repair procedures
| Removal |
| 1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - " Air Cleaner)
|
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 3. |
Remove the ECM.
(Refer to Engine Control System - "ECM")
|
| 4. |
Remove the snap pin (A-2ea) and then removing the select cable (B) and
shift cable (C).
|
| 5. |
Remove the control shaft assembly (A) after loosen the bolts.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
| 2. |
After installing, check to be sure that this part operates as designed
at each range of transaxle side corresponding to each position of shift
lever.
|
Control Cable
Components and components location
Components
1. Shift lever knob & boots
2. Shift lever assembly
3. Shift cable
4. Select cable
5. Retainer
6. 4th ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Ignition Coil
Description and operation
Description
An ignition coil is an induction coil in an engine's ignition system which transforms
the battery's low voltage to the high voltage needed to create an electric spark
in the spark plugs to ignite the fuel. Coils have an internal re ...
Hyundai Creta GS 2014-2019 Service Manual: Front Door Latch
Components and components location
Component Location
1. Front door latch
Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
...
© 2017-2026 www.hcrmangs.com
