Hyundai Creta: Starting System / Description and operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

1. Magnet switch assembly
2. Brush holder assembly
3. Armature assembly
4. Over runing clutch assembly

Starting System
...

Troubleshooting
Troubleshooting    • The battery must be in good condition and fully charged for ...

Other information:

Hyundai Creta GS 2014-2020 Service Manual: Schematic diagrams
Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. Purge Control Solenoid Valve (PCSV) ...

Hyundai Creta GS 2014-2020 Service Manual: Rear Washer Switch: Repair procedures
Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position according to the table. [Left Handle Drive] Switch Switch position ...

© 2017-2020 www.hcrmangs.com