Hyundai Creta: Front Suspension System / Front Lower Arm: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Suspension System / Front Suspension System / Front Lower Arm: Repair procedures

Removal

Remove the front wheel and tire (A).

Tightening torque :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

•	Be careful not to damage the hub bolts when removing the front wheel & tire.

Remove the tie rod end ball joint.

(1)	Rmove the split pin (A).

(2)	Loosen the nut (B).

(3)

Separate the ball joint from the knuckle.

Tightening torque :

23.5 ~ 33.3 N.m (2.4 ~ 3.4 kgf.m, 17.4 ~ 24.6 lb-ft)

Remove the lower arm (B) from the knuckle by loosening the mounting nut (A).

Tightening torque :

78.5 ~ 88.3 N.m (8.0 ~ 9.0 kgf.m, 57.9 ~ 65.1 lb-ft)

Remove the front lower arm (A) and than loosen the bolts & nuts.

Tightening torque

Fornt : 117.7 ~ 137.3 N.m (12.0 ~ 14.0 kgf.m, 86.8 ~ 101.3 lb-ft)

Rear : 157.0 ~ 176.6 N.m (16.0 ~ 18.0 kgf.m, 115.7 ~ 130.1 lb-ft)

5.	Install in the reverse order of removal.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the lower arm for bending or breakage.

3.	Check the lower arm for deformation.

4.	Check the all bolts and nuts.

Front Strut Assembly

Components and components location Components 1. Dust cover 2. Upper mounting nut 3. Self locking nut 4. Insulator 5. Spring upper pad 6. Stru ...

Front Stabilizer Bar: Repair procedures

Removal 1. Remove the front wheel and tire (A). Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Transmitter: Repair procedures
Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn't flicker. Standard v ...

Hyundai Creta GS 2014-2019 Service Manual: Special service tools
Special Service Tools Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture (Beam) Removal and installation of the transaxle. Use this beam (SST No. : 09200-3N000) with t ...