Hyundai Creta: Interior Trim / Front Pillar Trim

Components and components location

Component Location

1. Front pillar trim


Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the front pillar trim (A).

2.
To install, reverse the removal procedure.
  
Replace any damaged clips.
Cowl Side Trim
Components and components location Component Location 1. Cowl side trim Repair procedures Replacement   ...

Center Pillar Trim
Components and components location Component Location 1. Center pillar lower trim 2. Center pillar upper trim Repair procedures Replacement ...

Other information:

Hyundai Creta GS 2014-2021 Owners Manual: Windshield defrosting and defogging
WARNING Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. Set the mode select ...

Hyundai Creta GS 2014-2021 Owners Manual: Windshield wipers
Operates as follows when the ignition switch is in the ON position. MIST : For a single wiping cycle, move the lever to or MIST position and release. The wipers will operate continuously if the lever is held in this position. OFF : Wiper is not in operation. INT : Wiper operates inter ...

© 2017-2021 www.hcrmangs.com