Hyundai Creta: Windshield Wiper/Washer / Front Washer Motor: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor: Repair procedures

Inspection
Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
  
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
3.
If they are abnormal, replace the washer motor.
No
Description
1
 Windshield washer (+)
2
 Ground
3
 Rear washer (+)

Removal
  
–
When servicing the washer pump, be careful not to damage the washer pump seal.
–
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front right wheel guard.
(Refer to Body - "Front Wheel Guard")
3.
Remove the washer reservoir after loosening the mounting bolts (A) and disconnect the washer motor connector.
4.
Remove the washer motor (A).
Installation
1.
Reassemble the washer reservoir.
  
•
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Connect the washer motor connector and washer hose.
3.
Reassemble the front bumper cover.
Front Wiper Motor
Components and components location Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & ...

Rear Wiper/Washer
...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting Symptom Suspected Area Remedy  Clutch grabs/chatters Engine mounting (Loose) Tighten the engine mounting. Clutch disc assembly (Excessive runout) Inspect the ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Repair procedures Bleeding of Brake System This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brak ...

© 2017-2026 www.hcrmangs.com