Hyundai Creta: Body Side Molding / Roof Side Molding: Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof side molding (A).
  
Relplace the roof side molding to a new one.

2.
To install, reverse the removal procedure.
  
Replace any damaged clips.
Roof Rack: Repair procedures
Replacement    • Put on gloves to protect your hands. ...

A Pillar Garnish: Repair procedures
Replacement    • Put on gloves to protect your hands. ...

Other information:

Hyundai Creta GS 2014-2021 Service Manual: Rear Hub - Carrier
Components and components location Components 1. Dust cover 2. Rear hub assembly 3. Rear brake disc Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely s ...

Hyundai Creta GS 2014-2021 Service Manual: Troubleshooting
Standard Flow of Diagnostic Troubleshooting Notes With Regard To Diagnosis The phenomena listed in the following table are not abnormal. Condition Explanation System check sound When starting the engine, a thudding sound can so ...

© 2017-2021 www.hcrmangs.com