Hyundai Creta: Crash Pad / Glove Box Housing
Components and components location
Repair procedures
| • |
Put on gloves to protect your hands.
|
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
|
| 2. |
Disconnect the pins (A) and then remove the glove box (B).
|
| 3. |
After loosening the mounting screws, then remove the glove box housing
(A).
|
| 4. |
To install, reverse the removal procedure.
| •
|
Make sure the connector are connected in properly.
|
| •
|
Replace any damaged clips.
|
|
|
Components and components location
Component Location
1. Crash pad lower panel
Repair procedures
Replacement
...
Components and components location
Component Location
1. Steering column shroud lower
panel
2. Steering column shroud upper
panel
Repair proce ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Manifold Absolute Pressure Sensor (MAPS)
Description and operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM. By
using ...
Hyundai Creta GS 2014-2019 Owners Manual: Windshield wipers
Operates as follows when the ignition
switch is in the ON position.
MIST : For a single wiping cycle,
move the lever to or MIST
position and release. The
wipers will operate continuously
if the lever is held in this
position.
OFF : Wiper is not in operation.
INT : Wiper operates inter ...
Crash Pad Lower Panel
Steering Column Shroud Panel