| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loose the screws (2EA) holding the rear combination lamp then disconnect
the connector (A) then remove the outside rear combination lamp (B).
|
| 3. |
If it is necessary to replace the bulb, remove the rear combination
cover (A).
|
| 4. |
Disconnect the rear combination lamp connecter (C).
|
| 5. |
Remove the Back up lamp (A).
|
| 6. |
Remove the Tail lamp (B).
|
| 7. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
| 8. |
Remove the inside rear combination lamp assembly (A) after loosening
the nuts (4EA) and disconnecting the connector.
|
| 9. |
Remove the Turn signal lamp bulb (A).
|
| 10. |
Remove the stop lamp bulb (B).
|
| 11. |
If it is necessary to replace the bulb, remove the bulb after removing
the tailgate cover.
|
| Installation |
| 1. |
Install the tailgate combination lamp assembly after assembling the
bulb.
|
| 2. |
Install the lamp cover to the tailgate after connecting the lamp connector.
|
| 3. |
Install the rear combination lamp assembly after assembling the bulbs
and connecting the lamp connector.
|
Luggage Room Lamp: Repair proceduresHyundai Creta GS 2014-2019 Service Manual: Accelerator Position Sensor (APS)
Description and operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module
and detects the rotation angle of the accelerator pedal. The APS is one of the
most important sensors in engine control system, so it consists of the two sensor ...
Hyundai Creta GS 2014-2019 Service Manual: Photo Sensor
Description and operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The
solar radiation received by its light receiving portion, generates an electromotive
force in ...