Hyundai Creta: Driver assist system / Rear parking assist system

The Rear Parking Assist System aids the driver during reverse movement of the vehicle by chiming if any object is sensed within the distance of about 120 cm (47 in.) behind the vehicle.

This is a supplemental system that senses objects within the range and location of the sensors, it cannot detect objects in other areas where sensors are not installed.

WARNING

Operation of the rear parking assist system

Operation condition

Types of warning indicator and sound

NOTICE

If this occurs, we recommend that the system be checked by an authorized HYUNDAI dealer.

Non-operational conditions of rear parking assist system

The rear parking assist system may not operate normally when:

There is a possibility of a parking assist system malfunction when:

Detecting range may decrease when:

The following objects may not be recognized by the sensor:

Information

The system may not recognize objects less than 30 cm (12 in.) from the sensor, or it may sense an incorrect distance.

NOTICE

Do not push, scratch or strike the sensor with any hard objects that could damage the surface of the sensor. Sensor damage could occur.

WARNING

Your new vehicle warranty does not cover any accidents or damage to the vehicle or injuries to its occupants due to a rear parking assist system malfunction. Always drive safely and cautiously.

Rear view camera
The Rear View Camera will activate when the engine is running and the shift lever is in the R (Reverse) position. Whenever the vehicle ignition is cycled off and on, the rear view camera wi ...

Climate control system
...

Other information:

Hyundai Creta GS 2014-2020 Service Manual: Side Impact Sensor (SIS)
Description and operation Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to collision at their mounting locations. The primary purpose ...

Hyundai Creta GS 2014-2020 Service Manual: Schematic diagrams
Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. Purge Control Solenoid Valve (PCSV) ...

© 2017-2020 www.hcrmangs.com