Hyundai Creta: Rear Seat / Rear Seat Assembly

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Assembly

Components and components location

Component Location

[ 6:4 Back folding type ]

1. Rear seat cushion assembly

2. Rear seat back assembly

[Banch seat type]

1. Rear seat cushion assembly

2. Rear seat back assembly

Repair procedures

Replacement

[Rear seat cushion assembly]

(6:4 Back folding type)

1.	Remove the luggage board (A).

After loosening the mounting bolt (B), remove the rear seat cushion assembly (A).

※ Rear seat cushion separation method.

a.	Loosen the mounting bolt (B).

b.	Remove the rear seat cushion by pulling upward.

3.	To install, reverse the removal procedure.

(Banch seat type)

4.	Remove the luggage board (A).

After loosening the mounting bolt (B), remove the rear seat cushion assembly (A).

※ Rear seat cushion separation method.

a.	Loosen the mounting bolt (B).

b.	Remove the rear seat cushion by pulling upward.

6.	To install, reverse the removal procedure.

[Rear seat back assembly]

(6:4 Back folding type)

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Pull up the seat by pulling the stand-up lever.

After loosening the mounting bolts, remove the rear seat back assembly (A).

Tightening torque :

19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

4.	To install, reverse the removal procedure.

(Banch seat type)

5.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

6.	Pull up the seat by pulling the stand-up lever.

After loosening the mounting bolts, remove the rear seat back assembly (A).

Tightening torque :

19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

8.	To install, reverse the removal procedure.

Components and components location

Components [ 6:4 Back folding type ] 1. Rear seat cushion pad 2. Rear seat cushion cover 3. Rear console armrest 4. Rear seat back cover 5. Re ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS)
Description and operation Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, fuel is not supplied.That is, vehicle can't run without CKPS sig ...

Hyundai Creta GS 2014-2019 Service Manual: Rear Door Belt Inside Weatherstrip: Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To install, reverse the removal procedure. ...