Hyundai Creta: Crankcase Emission Control System / Repair procedures

Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.
  
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose.
Schematic diagrams
Schematic Diagram ...

Positive Crankcase Ventilation (PCV) Valve
Description and operation Operation Principle Repair procedures Removal 1. Disconnect the vapor hose (A). 2. Remove the ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Drive Belt
Components and components location Components 1. Drive Belt Repair procedures Removal and Installation 1. Disconnect the battery negative terminal. 2. Loosen the alternator mounting bolts (A) ...

Hyundai Creta GS 2014-2019 Service Manual: General information
General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work.    The support rod must be inserted into the hole near the edge of the ...

© 2017-2019 www.hcrmangs.com