Hyundai Creta: Fender / Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement

•	Be careful not to damage the fender and body.

•	When removing the clips, use a clip remover.

1.	Remove the front bumper. (Refer to Front Bumper - "Front Bumper Cover")

2.	Remove the head lamps. (Refer to Body Electrical System - "Head Lamps")

3.	Remove the front wheel guard. (Refer to Body Side Molding - "Front Wheel Guard")

4.	Remove the fender garnish. (Refer to Body Side Molding - "Fender Garnish")

5.	Remove the side sill molding. (Refer to Body Side Molding - "Side Sill Molding")

6.	Remove the front bumper side mounthing bracket (A) after loosening the screw and bolt.

7.	Remove the fender assembly (A) after loosening the bolts.

To install, reverse the removal procedure.

•	Replace any damaged clips.

Components and components location

Component Location 1. Fender assembly ...

Hood

...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Rear Combination Lamp: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp (B). ...

Hyundai Creta GS 2014-2019 Owners Manual: Key ignition switch
WARNING NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control ...