| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
|
| 3. |
Remove the steering column upper and lower shrouds after loosening the
screws.
(Refer to Body - "Steering Column Shroud Panal")
|
| 4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
|
| 5. |
Disconnect the multifunction switch connector (A).
|
| 6. |
Remove the multifunction switch assembly (A) after loosening the screws.
|
| Installation |
| 1. |
Install the multifunction switch.
|
| 2. |
Install the clock spring.
|
| 3. |
Install the steering column upper and lower shrouds.
|
| 4. |
Install the steering wheel.
|
| Inspection |
| 1. |
Check for continuity between the terminals in each switch position as
shown below.
[Left Handle Drive]
[Right Handle Drive]
|
Components and components location
AudioHyundai Creta GS 2014-2019 Service Manual: Roof Antenna
Components and components location
Components
[Roof Antenna (AM/FM+GPS)
for AVN Head Unit]
Repair procedures
Removal
1.
Remove the rear roof trim.
(Refer to Body - "Roof Trim Assembly")
2.
...
Hyundai Creta GS 2014-2019 Service Manual: General information
Tightening Torque Table
of Standard Parts
BOLT (Nominal diameter)
NUT (Nominal diameter)
BOLT/NUT Normal screw
Torque Nm (kg.m, Ib-ft)
Nominal diameter.
...