Hyundai Creta: Lighting System / Room Lamp: Repair procedures

Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the room lamp connector (A).

Removal
Room Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Carefully remove the lamp lens (A) from the room lamp with a flat-tip screwdriver.

3.
Replace the bulbs (A) and remove the screws if it is necessary.

4.
Remove the room lamp assembly (A) after disconnecting the connector (B).

Installation
Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
Head Lamps
Components and components location Component [General] 1. Head lamp High/Low beam bulb 2. Dust cap 3. Turn signal lamp bulb [Bi- ...

Overhead Console Lamp: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary to replace the bulb only, replace the bulb after opening the ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Engine Mounting
Components and components location Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket Repair procedures Removal and Installation Roll rod Bracket 1. ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Repair procedures Bleeding of Brake System This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brak ...

В© 2017-2026 www.hcrmangs.com