Inspection |
1. |
Disconnect the battery negative terminal.
|
2. |
Remove the fuse box cover.
|
3. |
Remove the starter relay (A).
|
4. |
Using an ohmmeter, check that there is continuity between each terminal.
|
5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
6. |
If there is no continuity, replace the starter relay.
|
7. |
Install the starter relay.
|
8. |
Install the fuse box cover.
|
Hyundai Creta GS 2014-2024 Owners Manual: Windshield washers
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will continue
until you release the lever.
If the washer does not work, check
...
Hyundai Creta GS 2014-2024 Owners Manual: Driving at night
Night driving presents more hazards
than driving in the daylight. Here are
some important tips to remember:
Slow down and keep more distance
between you and other vehicles,
as it may be more difficult to
see at night, especially in areas
where there may not be any street
light ...