In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
WARNING
When the outside temperature is below freezing, ALWAYS warm the windshield using the defroster to prevent the washer fluid from freezing on the windshield and obscuring your vision which could result in an accident and serious injury or death.
NOTICE
Hyundai Creta GS 2014-2024 Service Manual: Evaporator Temperature Sensor
Description and operation
Description
The evaporator temperature sensor will detect the evaporator core temperature
and interrupt compressor relay power in order to prevent evaporator from freezing
by excessive cooling. The evaporator temperature sensor has the Negative Temper ...
Hyundai Creta GS 2014-2024 Service Manual: Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM (ECM) or when
providing additional keys to the vehicle owner.
The procedure starts with an PCM (ECM) request for vehicle specific
...