Hyundai Creta: Wipers and washers / Windshield wipers
Operates as follows when the ignition switch is in the ON position.
MIST : For a single wiping cycle, move the lever to or MIST position and release. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at the same wiping intervals. To vary the speed setting, move the speed control lever.
Information
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
If you do not remove the snow and/or ice before using the wiper and washer, it may damage the Wiper and washer system.
Wipers and washers
A : Wiper speed control (front)
/ MIST – Single wipe
O / OFF – Off
--- / INT – Intermittent wipe
AUTO* – Auto control wipe
1 / LO– Low wiper speed
2 / HI – High wiper speed ...
Windshield washers
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. Use this function
when the windshield is dirty. The
spray an ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Description and operation
Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications
and the addition of special control components.
Modifications to the combustion chamber, intake manifold, camshaft and ignition
system form the basic control system.
Thes ...
Hyundai Creta GS 2014-2019 Service Manual: Control Shaft Assembly
Description and operation
Description
Control shaft assembly is mounted on the top of the manual transmission, and
select & shift cable are equipped.
Control shaft assembly is operated by shifting the shift lever.
Repair procedures
Removal
1.
...
