Hyundai Creta: Automatic Transaxle Control System / Repair procedures

Adjustment

Transaxle Control Module (TCM) Learning

When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.

In the following case, TCM learning is required.

•	Transaxle assembly replacement

•	TCM replacement

•	TCM upgrading

TCM learning procedure

1.	Automatic Transaxle Fluid (ATF) temperature: 40 ~ 100°C (104 ~ 212°F)

2.	Static learning Repeat the below shift pattern four times or more with stepping on the brake.

3.	Driving learning Drive the vehicle from a stop in D through all gears 1st, 2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the specified Throttle Position Sensor (TPS) value (15 ~ 25%).

Circuit Diagram ...

Description and operation Description • Monitoring the vehicle's operating conditions to determine the optimal gear setting. • ...

Hyundai Creta GS 2014-2019 Service Manual: Front Lower Arm: Repair procedures
Removal 1. Remove the front wheel and tire (A). Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Hyundai Creta GS 2014-2019 Service Manual: Clutch Release Fork and Clutch Release Bearing
Components and components location Components 1. Clutch release fork 2. Clutch cover assembly 3. Clutch disk assembly 4. Clutch release bearing Repair procedures Removal 1. Remove the manual transaxle assembly. ...