Hyundai Creta: Charging System / Battery Sensor

Description and operation

Description
Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a stable power supply as there diverse sensors giving a variety of information. Battery sensor (A) is mounted on battery (-) terminal. It transmits battery voltage, current, temperature information to ECM. ECM controls generating voltage by duty cycle based on these signals.

Repair procedures

Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolt (B).

Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation bolt :
21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~23.9 lb-ft)
Battery (-) terminal l tightening nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Battery
Description and operation Description 1. The MF(Maintenance Free) battery is, as the name implies, totally maintenance free and has no removable battery cell caps ...

Starting System
...

Other information:

Hyundai Creta GS 2014-2020 Service Manual: Junction Box (Engine Compartment)
Components and components location Component Location E/R Junction Block PCB Block (G4FC) PCB Block (D4FC/D4FB) Repair procedures Inspection PCB block 1. Disconnect the negative (-) batt ...

Hyundai Creta GS 2014-2020 Service Manual: Side Impact Sensor (SIS)
Description and operation Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to collision at their mounting locations. The primary purpose ...

© 2017-2020 www.hcrmangs.com