Hyundai Creta: Ignition System / Description and operation

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

Repair procedures

On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Description and operation
Description This specification applies to HCU(Hydraulic Control Unit) and ECU(Electronic Control Unit) of the HECU.(Hydraulic and Electronic Control Unit) This specification is for the wiring design and installation of ABS/ESP ECU. This unit has the functions as follows. ...

Hyundai Creta GS 2014-2019 Service Manual: Oil Pressure Switch: Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover. (Refer to Engine And Transaxle Assmbly - "Engine Room Under Cover" ) 3. Drain the e ...