Hyundai Creta: Fuel Delivery System / Filler-Neck Assembly: Repair procedures

Removal

1.	Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

2.	Lift the vehicle.

3.	Remove the rear-LH wheel, tire, end the inner wheel house.

4.	Disconnect the fuel filler hose (A), the vapor hose (B) and the leveling quick connector (C).

5.	Remove the filler-neck assembly from the vehicle after removing the bracket installation nut/ bolt (D).

Installation

1.	Install in the reverse order of removal.

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") ...

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the accelerator position senso ...

Hyundai Creta GS 2014-2024 Service Manual: Troubleshooting
Troubleshooting Trouble Symptom Cause of the symptom Remedy Excessive play in steering Loose U-joint bolt Retighten or replace as necessary Loose yoke plug Retighten ...

Hyundai Creta GS 2014-2024 Service Manual: Components and components location
Components 1. Cylinder block 2. Ladder frame 3. Crankshaft 4. Crankshaft upper bearing 5. Crankshaft lower bearing 6. Thrust bearing 7. Main bearing 8. Flywheel 9. Crankshaft sproket 10. Crankshaft pulley 11. Drive plate 12. A ...