Hyundai Creta: Cylinder Block Assembly / Drive Plate: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Mechanical System / Cylinder Block Assembly / Drive Plate: Repair procedures

Removal and Installation

1.	Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")

Remove the adapter plate (A) and drive plate (B).

Tightening torque :

71.5 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.6 lb-ft)

3.	Install in the reverse order of removal.

Components and components location

Components 1. Cylinder block 2. Ladder frame 3. Crankshaft 4. Crankshaft upper bearing 5. Crankshaft lower bearing 6. Thrust bearing 7. Main bearing ...

Flywheel: Repair procedures

Removal and installation 1. Remove the manual transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2. Remov ...

Other information:

Hyundai Creta GS 2014-2019 Owners Manual: Owner's responsibility
Information Maintenance Service and Record Retention are the owner's responsibility. We recommend in general that you have your vehicle serviced by an authorized HYUNDAI dealer. You should retain documents that show proper maintenance has been performed on your vehicle in accordance ...

Hyundai Creta GS 2014-2019 Owners Manual: Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or ...