Hyundai Creta: ESP(Electronic Stability Program) System / ESP OFF Switch

Description and operation

Description
1.
The ESP OFF switch is for the user to turn off the ESP system.
2.
The ESP OFF lamp is on when ESP OFF switch is engaged.

Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad side switch assembly.
(Refer to Body - "Crash Pad")

3.
Install in the reverse order of removal.
Inspection
1.
Check the continuity between the switch terminals as the ESP OFF switch is engaged.

No
Connector
1
IGN1
2
-
3
RHEO_UP
4
RHEO_DOWN
5
-
6
TAIL
7
-
8
ESP
9
-
10
GND
11
-
12
ILL-

ESP Control Unit
Components and components location Components [LHD] 1. Front - RH 2. Rear - LH 3. Rear - RH 4. Front - LH 5. MC2 6. MC1 7. ESP control ...

Steering Angle Sensor: Description and operation
Description Steering angle sensor The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. ...

Other information:

Hyundai Creta GS 2014-2024 Service Manual: Piston and Connecting Rod
Components and components location Components 1. Piston ring (#1) 2. Piston ring (#2) 3. Oil ring 4. Piston 5. Piston pin 6. Connecting rod 7. Connecting rod upper bearing 8. Connecting rod lower bearing 9. Connecting rod bearing cap ...

Hyundai Creta GS 2014-2024 Service Manual: Rear torsion beam axle
Components and components location Components 1. Rear torsion beam axle Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. ...

© 2017-2024 www.hcrmangs.com