Hyundai Creta: Heater / Heater Core: Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening the mounting screws.

4.
Pull out the heater core (A) from the heater unit.

5.
Install in the reverse order of removal.
If you're installing a new heater core, add refrigerant oil (PAG OIL).
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
Apply sealant to the grommets.
Make sure that there is no air leakage.
Charge the system and test its performance.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
Heater Unit
Components and components location Component Location 1. Heater unit assembly Compoents (1) 1. Heater core cover 2. He ...

Evaporator Core: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Hea ...

Other information:

Hyundai Creta GS 2014-2021 Service Manual: Starter Relay: Repair procedures
Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay (A). 4. Using an ohmmeter, check that there is continuity b ...

Hyundai Creta GS 2014-2021 Service Manual: Drive Belt Tensioner
Components and components location Components Repair procedures Removal 1. Loosen the drive belt tension by loosening the adjusting bolt (A). 2. Remove the alternator upper mounting bolt (B). 3. ...

© 2017-2021 www.hcrmangs.com