Hyundai Creta: Braking system / Hill-Start Assist Control (HAC)
A vehicle has the tendency to slide backwards on a steep slope, before depressing the accelerator after a stop. The HAC prevents the vehicle from sliding backwards by automatically operating the brake systems for about 2 seconds. The brake systems are automatically released, when the accelerator pedal is depressed
WARNING
The HAC is activated only for about 2 seconds, so always depress the accelerator pedal to begin driving upwards after a stop.
Information
- The HAC does not operate when the shift lever is in P (Park) or N (Neutral)
- The HAC activates even when the ESC (Electronic Stability Control) is off. However, it does not activate, when the ESC does not normally operate.
Vehicle Stability Management
Vehicle Stability Management (VSM)
helps ensure the vehicle stays stable
when accelerating or braking suddenly
on wet, slippery and rough
roads where traction over the four
tires can suddenl ...
Good braking practices
WARNING
Whenever leaving the vehicle or
parking, always come to a complete
stop and continue to depress
the brake pedal. Move the shift
lever into the 1st gear (for manual
transaxle vehicle ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Door glass fails to operate up and down
Incorrect window glass installation
Adjust position
Damaged or faulty regulator arm or reg ...
Hyundai Creta GS 2014-2019 Service Manual: Intake Actuator
Components and components location
Components Location
1. Intake actuator
Description and operation
Description
The intake actuator is located at the blower unit. It regulates the intake door
by a signal from the control unit. Pre ...
