Hyundai Creta: Power Door Locks / Power Door Lock Actuators: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators: Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

Disconnect the connectors from the actuator.

No	Pin information
No	LH	RH
1	Motor 1	AJAR Switch
2	Motor 2	COM
3	-	Lock / UnLock switch
4	Key Unlock switch	Key Lock switch
5	Key Lock switch	Key Unlock switch
6	Lock / UnLock switch	-
7	COM	Motor 2
8	AJAR Switch	Motor 1

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Latch Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear latch. (Refer to Body - "Rear Door Latch")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Lock Module Inspection

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the 4P connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the switch connector.

3.	Check for continuity between the terminals in each switch position according to the table.

Hood Switch

1.	Disconnect the connector (A) and bolts from the hood switch.

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn

1.	Remove the burglar horn (A) after removing a bolt and disconnect the 2P connector from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should sound. If the burglar horn fails to sound replace it.

Components and components location

Component Location 1. Driver power window main switch 2. Body Control Module (BCM) 3. Door look switch 4. Tailgate lock actuator & switch 5. Front door ...

Power Door Lock Switch: Repair procedures

Diagnosis with GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Valve Body
Description and operation Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pressure regulator valves, oil redirection valves, shift valves ...

Hyundai Creta GS 2014-2019 Owners Manual: Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. HI – High wiper speed LO – Low wiper speed OFF – Off Push the lever away from you to spray rear ...