Hyundai Creta: Body Side Molding / Quarter Garnish: Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the quarter garnish (A).

2.
To install, reverse the removal procedure.
  
Replace any damaged clips.
[Quarter fixed garnish]
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver, remove the quarter fixed garnish (A).

2.
To install, reverse the removal procedure.
  
Replace any damaged clips.
Fender Garnish: Repair procedures
Replacement    • Put on gloves to protect your hands. ...

Door Garnish: Repair procedures
Replacement    • Put on gloves to protect your hands. ...

Other information:

Hyundai Creta GS 2014-2021 Service Manual: Power Seat Control Switch
Schematic diagrams Circuit Diagram Repair procedures Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. ...

Hyundai Creta GS 2014-2021 Service Manual: Compressor
Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-te ...

© 2017-2021 www.hcrmangs.com