Hyundai Creta: Cylinder Block Assembly / Rear Oil Seal: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Mechanical System / Cylinder Block Assembly / Rear Oil Seal: Repair procedures

Replacement

Remove the transaxle.

•	Automatic Transaxle (Refer to Automatic Transaxle System - "Automatic Transaxle")

•	Manual Transaxle (Refer to Manual Transaxle System - "Manual Transaxle")

Remove the drive plate or flywheel.

•	Automatic Transaxle (Refer to Cylinder Block Assembly - "Drive Plate")

•	Manual Transaxle (Refer to Cylinder Block Assembly - "Flywheel")

3.	Remove the rear oil seal (A).

Install a new rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using the SST (09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

5.	Install the other parts in the reverse order of removal.

Flywheel: Repair procedures

Removal and installation 1. Remove the manual transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2. Remov ...

Piston and Connecting Rod

Components and components location Components 1. Piston ring (#1) 2. Piston ring (#2) 3. Oil ring 4. Piston 5. Piston pin 6. Connecting rod 7. Co ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Components 1. Rear door trim 2. Rear door belt inside weatherstrip 3. Rear door trim seal 4. Rear door panel 5. Rear door belt outside weatherstrip 6. Rear door body side weatherstrip 7. Rear door side weatherstrip 8. Rear door hinge ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of th ...