Hyundai Creta: General Information / Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Restraint / General Information / Repair procedures

Component Replacement After Deployment

•	Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

When the front airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Seat belt pretensioner(s)

–	Front impact sensors

–	SRS wiring harnesses

–	Inspect the clock spring for heat damage. If any damage found, replace the clock spring.

When the side/curtain airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Side impact sensor(s) for the deployed side(s)

–	SRS wiring harnesses

–	Seat belt pretensioner(s)

After the vehicle is completely repaired, confirm the SRS airbag system is OK.

–	Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

Description and operation

Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the wa ...

Components and components location

Components Location Supplemental Restraint System Control Module (SRSCM) 1. Supplemental Restraint System Control Module (SRSCM) ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Rear Washer Switch: Repair procedures
Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position according to the table. [Left Handle Drive] Switch Switch position ...

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Components Location 1. Valve body assembly 2. Automatic transaxle 3. Valve body cover 4. Air breather hose 5. Air breather hose clamp 6. Valve body cover gasket 7. Solenoid valve connector ...