Hyundai Creta: Lighting System / Turn Signal Lamp: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body Electrical System / Lighting System / Turn Signal Lamp: Repair procedures

Removal

Door Mirror Turn Signal Lamp

1.	Disconnect the negative (-) battery terminal.

Remove the mirror holder (A) from the outside mirror assembly.

•	Be careful not to damage the fixing clip

3.	Remove the door mirror cover (A).

4.	Loosen the mirror turn signal lamp mounting screw.

5.	Remove the door mirror turn signal lamp (B) after disconnecting the connector (A).

Installation

Door Mirror Turn Signal Lamp

1.	Install the door mirror turn signal lamp.

2.	Install the door mirror cover and housing.

3.	Install the door mirror.

4.	Connect the negative (-) battery terminal.

Overhead Console Lamp: Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary to replace the bulb only, replace the bulb after opening the ...

Hazard Lamp Switch: Repair procedures

Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of th ...

Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine struggles to start Malfunction of the Purge Control Solenoid Valve ...