Hyundai Creta: Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Mechanical System / Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator: Repair procedures

Removal and Installation

1.	Disconnect the battery negative terminal.

2.	Remove the air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")

3.	Disconnect the lever (A) and hose (B).

Loosen the mounting bolts and then remove the VIS actuator (C).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.	Install in the reverse order of removal.

Air Cleaner

Components and components location Components 1. Air duct 2. Air cleaner lower cover 3. Air cleaner element 4. Air cleaner upper cover 5. Air intake hose ...

Intake Manifold

Components and components location Components 1. Intake manifold 2. MAP semsor 3. Electronic throttle body 4. Intake manifold gasket 5. Electronic throttl ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Water Temperature Control Assembly
Components and components location Components 1. Water temperature assembly 2. Engine coolant temperature sensor (ECTS) 3. Gasket 4. Water pipe Repair procedures Removal and Installation 1. Remove the engine cove ...

Hyundai Creta GS 2014-2019 Service Manual: Side Impact Sensor (SIS)
Description and operation Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to collision at their mounting locations. The primary purpose ...