Hyundai Creta: Tires and wheels / Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.
If you notice your vehicle vibrating when driving on a smooth road, your wheels may need to be rebalanced.
NOTICE
Improper wheel weights can damage your vehicle's aluminum wheels. Use only approved wheel weights.
Tire rotation
To equalize tread wear, it is recommended
that the tires be rotated
every 12,000 km (7,500 miles) or
sooner if irregular wear develops.
During rotation, check the tires for
correct balance.
...
Tire replacement
If the tire is worn evenly, a tread wear
indicator will appear as a solid band
across the tread. This shows there is
less than 1.6 mm (1/16 inch) of tread
left on the tire. Replace the tire ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM (ECM) or when
providing additional keys to the vehicle owner.
The procedure starts with an PCM (ECM) request for vehicle specific
...
Hyundai Creta GS 2014-2019 Owners Manual: Immobilizer system
The immobilizer system protects your
vehicle from theft. If an improperly
coded key (or other device) is used,
the engine’s fuel system is disabled.
When the ignition switch is placed in
the ON position, the immobilizer system
indicator should come on briefly,
then go off. If the indi ...
